One of the last steps before my project is ready for a initial release is have LOD for my castle. It is in the Tamriel worldspace, just above the mountain near Fort Greymoor. Neadless to say LOD would be nice for something in floating in the center of Skyrim, but no LOD would be better than what I have right now. All the pieces are there but some of them are out of position.
This is what I see now, both on the map and walking around. http://i.imgur.com/69Fcov4.jpg http://i.imgur.com/gBaJJd9.jpg http://i.imgur.com/XlISqSb.jpg
Here is what it should look like, with less quality of course. http://i.imgur.com/TwFde4d.jpg
Below are the cells that are taken up by the castle. I looked at the list in the Cell View window and took note of the cells with a * next to them and then checked to make sure part of the castle was actually in the cell.
Spoiler
-12,-1
-6,-4
-7,2
-7,-1
-7,-2
-7,-4
-8,0
-8,-1
-8,-2
-8.-3
-9,1
-9,0
-9,-1
-9,-2
-9,-3
-9,-4
-10,1
-10,0
-10,-1
-10,-2
-11,0
-11.-1
-11,-2
-12,-1
-6,-4
-7,2
-7,-1
-7,-2
-7,-4
-8,0
-8,-1
-8,-2
-8.-3
-9,1
-9,0
-9,-1
-9,-2
-9,-3
-9,-4
-10,1
-10,0
-10,-1
-10,-2
-11,0
-11.-1
-11,-2
And using http://forums.nexusmods.com/index.php?/topic/592745-skyrim-castle-mod-wip/page__st__140__p__5619679#entry5619679 from Tambo, I figured that the files I needed were these (enjoy my hard drive naming convention

I have tried regenerating the files, using just the level 4/8/16 files to see if one level was to blame. Everything looks normal in the CK and in game when you are close enough to not need LOD. Just kinda puzzled by this one...any insight/suggestions/"fool you made a noob mistake" comments are very welcome.