Unusual architectural question.
Posted: Wed Dec 07, 2016 4:45 pmI have been remodeling the battlements I created for Bal Isra, and among other things added a decorative arch extrusion.
The conundrum of the moment is how to do the up/down mesh arches so that they match the rest of the set.
Any ideas, clues, tutorials would be greatly appreciated. For the moment, I'm going to use a straight line extrusion, until I have the arches figured out. It doesn't help that an angled mesh is about 4.5 units longerthan the flat meshes either, which further complicates matters.
The conundrum of the moment is how to do the up/down mesh arches so that they match the rest of the set.
Any ideas, clues, tutorials would be greatly appreciated. For the moment, I'm going to use a straight line extrusion, until I have the arches figured out. It doesn't help that an angled mesh is about 4.5 units longerthan the flat meshes either, which further complicates matters.