Hi there,

A small question, I can make a height map (4096x4096 raw format IBM etc.etc.) and a esp (with TESannwyn) however once it's loaded into the CK, and I click on Heightmap Editing, I only see a partial bit of the map even if I zoom outwards from it. Is there a simple reason for this or am doing something wrong somewhere?

Thanks,

Nag.

Ok, now this is only a reminiscence, but you have to right click on the editor window (the one that shows the 3D landscape) and select the line that says something like "preferences...". There should be a whole list of options about LODs and one of these should be the one you're looking for.

I remember solving the same "problem" this way.